Your document can be opened using the below link


Thank you, please click link below to continue

low viscosity elastomers advancedengineering electronics/optoelectronics




LCE Fluoro Elastomer;Recommend for short term fuel or solvent exposure.


  • Two-part, translucent fluorosilicone elastomer used with liquid injection molding equipment
  • 1:1 Mix Ratio (Part A:B)
  • Cures at room temperature or rapidly with heat
  • 50 mole % fluorosilicone


  • For applications requiring a medium hardness silicone and solvent resistance
  • Some typical applications include O-rings, gaskets, seals, and precision molded parts
  • Excellent for molding high quality parts at rapid rates
  • For applications requiring an operating temperature range of -65 to 240°C (-85 to 465°F)

Product Details

Property Average result
Cure System Platinum
Durometer 30 Type A
Tensile 700 psi
Elongation 360 %
Appearance Translucent
Cure 30 minutes / 150 °C
Extrusion Rate 120 g/minute
Mix Ratio 1:1
Operating Temperature -65 °C / 240 °C
Specific Gravity 1.26
Work Time 12 hours
Comment LCE Fluoro Elastomer;Recommend for short term fuel or solvent exposure.
Display in metric units

The above properties are tested on a lot-to-lot basis. Do not use as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.

Specialty Silicones for Displays

The NuSil™ line of optoelectronic silicones enable device manufacturers from smart phones to stadium screens and everything in between to create next-generation displays that are sharper, brighter and more rugged.

Read More