Thank you
×
Your document can be opened using the below link
Download Full Article
high consistency rubbers
lifesciences
generalhealthcare
Description
- Two-part, high tear strength silicone elastomer
- Cures with heat via addition-cure chemistry
- Has a non-tacky surface and no volatile by-products or peroxide residues
- Strained through a 400-mesh screen (minimum)
- 1:1 Mix Ratio (Part A: Part B)
Applications
- For a wide variety of fabrication techniques for the healthcare industry including: molding, calendering and extruding
NuSil Technology’s MED-4014 shall not be considered for use in human implantation for a period of greater than 29 days.
| Property |
Average result |
| Durometer |
15 Type A
|
| Tensile |
700 psi
|
| Elongation |
1,350 %
|
| Tear |
155 ppi
|
| Appearance |
Translucent |
| Cure |
10 minutes / 116 °C |
| Cure Rate Scorch |
1.25 minutes
|
| Cure Rate T90 |
2.5 minutes
|
| Cure System |
Platinum |
| Mix Ratio |
1:1 |
| Plasticity |
60 mils
|
| Specific Gravity |
1.08 |
| Stress @ Strain |
40 psi / 200 % |
| Work Time |
25 hours
|
| Comment |
Low modulus |
| Property |
Average result |
| Durometer |
15 Type A
|
| Tensile |
4.83 MPa
|
| Elongation |
1,350 %
|
| Tear |
27.34 kN/m
|
| Appearance |
Translucent |
| Cure |
10 minutes / 116 °C |
| Cure Rate Scorch |
1.25 minutes
|
| Cure Rate T90 |
2.5 minutes
|
| Cure System |
Platinum |
| Mix Ratio |
1:1 |
| Plasticity |
1.52 mm
|
| Specific Gravity |
1.08 |
| Stress @ Strain |
0.28 MPa / 200 % |
| Work Time |
25 hours
|
| Comment |
Low modulus |
Display in metric units
The above properties are tested on a lot-to-lot basis. Do not use as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
The Strongest Silicone Elastomer Ever Developed
Dr. Jim Lambert, NuSil™ Director of Research and Development, Biomaterials, introduces our breakthrough material that has a tensile strength of up to 50% greater than existing silicone elastomers on the market.
Read More