×

Your document can be opened using the below link

×

Thank you, please click link below to continue

×
×
coatings advancedengineering optoelectronics/electronics

R-2182

LOW COEFFICIENT OF FRICTION SILICONE COATING

 

Description

  • Two-part silicone elastomer dispersed in xylene
  • Cures to a smooth silicone film that decreases the coefficient of friction (CoF) compared to the uncoated silicone and increases abrasion resistance for moving, sliding, and rubbing parts
  • Provides adhesion to silicone substrates that results in a reduction of surface tack
  • 1:1 Mix Ratio (Part A: Part B)

Applications

  • To provide a heat-cured, low-friction coating on cured silicone substrates
  • Apply by spraying for best results (dipping may also be utilized)

Product Details

Property Average result
Viscosity 24 cP
Non-Volatile Content 25 %
Appearance A: Transluscent / B: Translucent to Opaque
Cure 5 minutes / RTV
Cure System Platinum
Mix Ratio 1:1
Post Cure 5 minutes / 150 C
Specific Gravity 0.96
Work Time >24 hours
Comment Requires minimum heat to cure. Acetic acid cure by-product therefore not recommended where corrosion is of concern.
Display in metric units
 

The above properties are tested on a lot-to-lot basis. Do not use as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.

NUSIL QUALITY SYSTEM (NQS™)


Developed in direct response to our work in the most challenging environments, NQS is a systematic approach to achieving consistent quality that goes far beyond what you'd expect.